Sygonix 1593775 Notice D'emploi page 48

• Use the device as a template
and mark the positions of the
drill holes on the wall. Select the
suitable drilling holes on the back
of the device. The holes should be
opposite to one another to ensure
maximum stability.
Use a 6 mm drill bit to drill at least 30 mm into the markings.
Depending on the surface material or mounting position, additional
parts may be required. These parts are not included in the assembly
kit.
The product must be connected by a professional technician or other
suitably qualified person.
• Push the dowels into the wall until they are completely inserted.
• Guide the cable through the relay
unit.
• Ensure that there is strain relief for
the cables inside the device. Replace
the terminal strip and reinsert the two
screws.
48