GYS STARTPACK PRO 12.24 Mode D'emploi page 9

Use in STARTER mode
• Unplug the socket from the mains.
• Disconnect the voltage selector
• Turn the battery-switch on OFF.
• Plug the red clamp to the (+) and the black clamp to the (-).
NB: In the event of polarity inversion, STARTPACK PRO 12.24 indicates red
LED lighting + alarm sound.
• Connect the voltage selector on 12V or 24V depending on the the vehicle you
wish to start.
• Turn the battery switch to ON
• Turn the key of your vehicle in order to activate the starter function
NB : if the vehicle does not start, wait 3 minutes between two attempts.
A vehicle which does not start after the third attempt probably has a problem
unrelated to the battery: alternator, spark plug,...
• Once the vehicle starts, turn the battery switch on OFF.
After a start or a high consumption of batteries, the red light will flash to
warn you that internal batteries should be recharged. This doesn't mean that
you can't try to start other vehicle.
• Disconnect the voltage selector from the 12V or 24V socket.
• Unplug the black clamp then the red clamp from the vehicle.
• Connect the device on a 230V 50/60Hz socket to recharge the batteries.
9