Operating Instructions - Abus PR2800 Notice De Montage Et D'utilisation

Fitting without screw-on plates with or without plastic underlays (Fig. 22)
1. Hold the lock case with the defined plastic underlay onto the marked lock case position.
Drill out holes with Ø 20 mm and a depth of 6 mm for unhinged doors and a rebate
< 3 mm on the mounting position. Bore through both mounting holes with Ø 10 mm and
a depth of at least 140 mm for the frame dowels. Insert dowel completely with the screw
and tighten.
If the screws or the dowels cannot find a secure grip, we recommend all-through screw
fittings with PV1820 (Fig. 29) or the use of composite mortar from well-known brands
(available from retailers) in connection with a cylinder screw with hexagon socket and
low profile head DIN 7984-M 8 x 120 – 8.8 or longer.
2. Press down the cover onto the
lock cases (Fig. 23).
3. Press the cylinder escutcheon firmly
onto the door exterior (Fig. 24).
4. The door bar can also be incorporated
into the wall instead of fitting the lock
case (Fig. 27). In this case, the cover for
the hole in the wall PWA2700 can be used.
5. Mount the cover for the hole in the wall
flush and fix in position with frame
dowels 10 x 120 mm or cement with
injection mortar.
Fig. 23
VII. Operating instructions
1. Close the door initially with the existing closing safety device. Then activate the
reinforced door bar PR2800 as additional protection using the key. Close the door
bar until the end stop by turning the key once or twice.
2. The PR2800 must be retracted the other way around until the end stop before opening
the door.
3. The reinforced door bar PR2800 is maintenance-free and does not require any lubricant.
Do not use any aggressive or abrasive cleaning products when cleaning the surfaces.
The ABUS care spray PS88 is suitable for cleaning the cylinder.
Fig. 22
Fig. 24
GB
85