Abus PR2800 Notice De Montage Et D'utilisation page 80

5. Remove the cylinder protection according to Fig. 8 and place additional spacer disc/s
(Tab. 1) between the cylinder protection and the lock body. Tighten with screws (Tab. 1).
6. Pull the gear-wheel housing into the old fitting position again (Fig. 7) and fix loosely
with screw 1 (Fig. 5.1).
7. Move the door bar casing to the marked position (Fig. 9).
8. Reinstall the door cylinder in the reverse order. If the indentations do not correspond,
loosen the stop screws (Fig. 6), pull both door bars out until the gear-wheels do
correspond and complete the installation of the door cylinder. Set the key pull-off
position by moving the stop slide if necessary. Retighten the stop screws.
Fig. 5
1.
2.
Fig. 6
Fig. 8
80
Fig. 5.1
1.
2.
Fig. 7
Fig. 9
5.
4.
2.
1. loosen
1.
6.
3.