Briteq BT-70LS Mode D'emploi page 7

ENGLISH
 Show 4: Fixture is fixed under ceiling. The spot is mainly projecting in
front of the stage. Pan movement angle (left to right to left):160°. Tilt
movement angle: 90° (vertically, front 75°; back 15°)
 Once the right mode is shown on the display, press the ENTER button to
select it.
 Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
Split Color
You can select if the unit can only show full colors or also split colors.
 Press the MENU button until "Split color" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "Yes" (Split colors) or "No" (only full
colors).
 Once the right mode is shown on the display, press the ENTER button to
select it.
 Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
Slave Mode
Used to make the slave unit work in opposite to the master or to work
in complete sync.
 Press the MENU button until "Slave Mode" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select Slave1 (normal) or Slave2 (2 light
show) mode.
 Once the right mode is shown on the display, press the ENTER button to
select it.
 Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in
blackout and waits for the DMX-signal.
No blackout mode: when no DMX-signal is detected, the unit
automatically switches to standalone mode.
 Press the MENU button until "Black Out" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "Yes" (blackout on) or "No" (blackout
off) mode.
 Once the right mode is shown on the display, press the ENTER button to
select it.
 Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
Sound State
The unit works to rhythm of the beat when used in standalone or
master/slave mode
 Press the MENU button until "Sound State" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "On" or "Off" mode.
 Once the right mode is shown on the display, press the ENTER button
select it.
 Press the MENU button for about 2 seconds to store the setting and to
return to running mode.
BRITEQ
®
5/79
OPERATION MANUAL
BT-70LS