Briteq BT-70LS Mode D'emploi page 11

ENGLISH
Electrical installation for two or more units in DMX-master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat but you can still
control some functions on the master by 1 or 5 DMX-channels.
 To assure proper operation you need an optional "Mini DMX-SPLITTER" to isolate the master/slave line
from the main DMX-line, see drawing.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will act as the master, the other units will act automatically as slaves.
 Set the master to 1MSL or 5MSL channel mode (see previous chapter). Check the DMX-chart below to
see the difference between both channel modes.
 For the DMX-controller the master and his slaves can now be considered as 1 virtual effect that needs a
start address so it can be controlled as any other DMX-unit in the DMX chain: see "DMX Address" in the
chapter "Main Menu" to see how you can set the DMX-start address.
 Make sure that all units are connected to the mains.
 Set the DMX-controller according to the DMX-chart below.
 Done!
Remark: in order to work well to the rhythm of the music, make sure that the option "Sound State" on the
master is set to "On" (see previous chapter)
DMX-Chart for 1MSL and 5MSL working modes
1 MSL
VALUE FUNCTION
248-255 RANDOM SHOW
188-247 SHOW 4
128-187 SHOW 3
068-127 SHOW 2
008-067 SHOW 1
000-007 STANDBY
1 – DIM
VALUE FUNCTION VALUE
255 100%
10
9
8
7
6
5
4
3
008 0%
2
000-007 STANDBY
1
Electrical installation in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality balanced cable.
 Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
Pin layout XLR-5pin:
BRITEQ
®
2 - STROBE
FUNCTION VALUE
255 FAST STROBE 248-255
218-247
188-217
158-187
128-157
098-127
068 SLOW STROBE 068-097
038-067 SOUND STROBE 038-067
008-037 RANDOM STROBE 008-037
000-007 OPEN 000-007
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used.
3 - COLOR
FUNCTION VALUE
ORIGINAL COL 248-255
COLOR 8 218-247
COLOR 7 188-217
COLOR 6 158-187
COLOR 5 128-157
COLOR 4 098-127
COLOR 3 068-097
COLOR 2 038-067
COLOR 1 008-037
WHITE 000-007
9/79
OPERATION MANUAL
4 - GOBO 5 - PAN/TILT SPEED
FUNCTION VALUE
ORIGINAL GOBO 248-255
FAST SCROLL 247
SLOW SCROLL
GOBO 6
GOBO 5
GOBO 4
GOBO 3
GOBO 2
GOBO 1 008
NO GOBO 000-007
FUNCTION
AUDIO TRIGGER
FAST
VERY SLOW
HOLD
BT-70LS