Briteq BT-70LS Mode D'emploi page 6

ENGLISH
2. FUNCTION LEDS
3. BUTTONS
4. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in
standalone or master/slave mode.
5. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
XLR-connectors.
6. MAINS FUSE: this fuse only protects the electronics of the projector, mains input/output (7) is not fused.
7. MAINS INPUT / OUTPUT: with PowerCON
daisy chain several units, up to max 16A. Input and output are connected to each other without any fuse.
Hint: Please check our website for special cable assemblies that contain both power (3x1.5mm² with Neutrik
®
PowerCON ) and balanced signal (XLR 3pin) in one cable. Different lengths are available: 1.3m, 3m, 5m and
10m, very convenient!
MAIN MENU:
 To select any of the functions, press the MENU button up to when the required one is shown on the
display or use the DOWN and UP buttons to browse the menu.
 Select the function with the ENTER button (the display blinks).
 Use DOWN and UP buttons to change the mode.
 Once the required mode is selected, press the ENTER button to select.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode. If you don't
do this, the setting will not be stored and after about 8 seconds, the fixture will return to the previous
running mode.
DMX Address
Used to set the starting address in a DMX setup.
 Press the MENU button until "DMX Address" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER button to select it.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Channel mode
Used to set the desired channel setup mode.
 Press the MENU button until "Channel mode" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to choose 1MSL, 5MSL, 1CH, 14CH or 15CH mode.
 Once the desired channel setup mode shows on the display, press the ENTER button to select it.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Show Mode
Used to choose the Show mode when used in standalone or master/slave mode.
 Press the MENU button until "Show Mode" is showing on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select one of the available shows:
 Show 1: Fixture is placed on the floor. Tilt movement angle 210°.
 Show 2: Fixture is fixed under ceiling. Tilt movement angle 90°.
 Show 3: Fixture is placed on a podium, in front of the audience. The spot is always projecting to
the audience's direction; i.e. in front of the stage. Pan movement angle (left to right to left): 160°. Tilt
movement angle: 90° (60° above horizon; 30° below horizon.)
BRITEQ
®
DMX On
MASTER On
SLAVE On
SOUND Flashing
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
DMX input present
Master mode
Slave mode
Sound activation
®
sockets, connect the supplied mains cable here, you can
4/79
OPERATION MANUAL
BT-70LS