Briteq BT-70LS Mode D'emploi page 16

ENGLISH
10
11
12
13
14
15
OPERATE THE UNIT BY CA8
When used in standalone or master/slave mode we strongly advise you to use the CA-
8 "Wired easy controller".
 Connect the controller to the jack input of the first unit (master).
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
 The LED is off: with the FUNCTION button you can select different strobe modes,
like "sound strobe".
 The LED is blinking: with the FUNCTION button you can select different shows.
 The LED is on: (music mode is temporarily switched off)
 Press the FUNCTION button shortly: to change the colors
 Press the FUNCTION button longer: to change the gobos
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
BRITEQ
®
Prism
000 - 007 No Effect
008 - 255 Prism Effect
Prism Rotation
000 - 127 Index position
128 - 189 Prism turning counter clockwise (fast → slow)
190 - 193 No rotation
194 - 255 Prism turning clockwise (slow → fast)
Focus
000 - 255 Focus setting
Pan Fine (Least significant bit)
000 - 255
Tilt Fine (Least significant bit)
000 - 255
Special functions
000 - 069 No function
070 - 079 Activate blackout during pan/tilt (*)
080 - 089 Disable blackout during pan/tilt (*)
090 - 099 Activate blackout during color change (*)
100 - 109 Disable blackout during color change (*)
110 - 119 Activate blackout during gobo change (*)
120 - 129 Disable blackout during gobo change (*)
130 - 199 No function
200 - 209 Reset all (*)
210 - 249 No function
250 - 255 Sound activated automatic mode
14/79
OPERATION MANUAL
BT-70LS