Bartscher AL 2 Mode D'emploi page 38

It is also possible to display the elapsed cooling time by pressing the button „cooling with
time regulation"
If you wish to remove the food product from the refrigerator-flash freezer, press the
START button
To place the unit in STANDBY mode, press and hold for 3 seconds one of the following
buttons
The internal unit temperature will be displayed in green.
The refrigerator-flash freezer is prepared for a new rapid cooling cycle.
To begin the next cooling cycle, press and hold for 3 seconds one of the following
buttons
„HARD" rapid cooling with temperature regulation via probe for
measuring internal product temperature
1. Insert the probe into the food product.
CAUTION!
Insert the internal product temperature probe into the food product to a maximum
depth of 2 – 3 cm.
2. Hold the button "cooling with temperature regulation via the probe for measuring
internal product temperature"
temperature. Press the button
„HARD".
After 3 seconds the display will show in red the internal unit temperature during rapid
cooling (-15° ). This value may be changed using the buttons marked
- 38 -
. The elapsed time will be displayed for 5 seconds in green.
to suspend the rapid cooling cycle.
.
.
. The display will show the current internal
again and hold until the display shows the word
or .