Section 2. Getting Ready To Sew; Connecting The Power Supply; Controlling The Sewing Speed - Janome 625E Livret D'instructions

q
r
Operating Instructions:
The symbol "O" of a switch indicates the "off" position of a switch.
For an appliance with a polarized plug (one blade wider than the other):
To reduce the risk of electrical shock, this plug is intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
The foot controller Model 21361 is used with the sewing machine Model 625E (USA market only).
t
w
y
e

SECTION 2. GETTING READY TO SEW

Connecting the Power Supply

z Turn the power switch off.
x Insert the controller plug and machine plug into the
machine socket.
c Insert the power supply plug into the wall outlet.
v Turn the power switch on.
q Power switch
e Controller plug
t Power supply plug
NOTE:
Before connecting to the power supply, make sure the
voltage shown on the machine conforms to your
electrical power.
WARNING:
While in operation, always keep your eyes on the sewing
area, and do not touch any moving parts such as the
thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise the
machine will run intermittently.

Controlling the Sewing Speed

Foot control
Sewing speed can be varied by the foot control.
The harder you depress the foot control, the faster the
machine runs.
Speed control slider
You can limit the maximum sewing speed with the speed
control slider according to your sewing needs.
To increase the sewing speed, move the slider to the
right.
To decrease the sewing speed, move the slider to the
left.
10
w Machine plug
r Machine socket
y Wall outlet