Removing The Batteries; Maintenance Contract; Frost Protection - Kärcher BD 43/25 C Bp Mode D'emploi

 Insert the battery into the device as
shown above.
 Insert the spacer between the battery
and the device on the side indicated in
the illustration.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Connect pole using the enclosed con-
necting cable.
 Connect the connection cable to the
free battery poles (+) and (-).
ATTENTION
If the polarity is reversed (positive and neg-
ative terminals), the control electronics are
destroyed.
Pay attention to correct poles.
 Place the waste water tank on the appli-
ance.
Note:
Charge the batteries before commissioning
the appliance.
See also "Charging the batteries".

Removing the batteries

 Set the programme selector switch to
"OFF".
 Pull out the battery plug.
 Lift up the waste water tank and put it
aside.
 Clamp off the minus pole of the battery.
 Clamp off the remaining cables from the
battery.
 Remove the support blocks or the foam
pieces.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Remove the batteries.
 Dispose of the used batteries according
to the local provisions.

Maintenance contract

To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.

Frost protection

In case of danger of frost:
 Empty the fresh and waste water tank.
 Store the appliance in a frost-protected
room.
7
-
EN 9