Removing The Batteries; Installing The Brushes - Kärcher BD 50/70 R Classic Mode D'emploi

Masquer les pouces Voir aussi pour BD 50/70 R Classic:

Mode d'emploi (51 pages)

Table des Matières

Les langues disponibles

Danger of explosion

Fire, sparks, naked flames and

smoking must be strictly avoided

Danger of chemical burns

First aid

Warning note

Disposal

Do not throw the battery into the

regular waste

DANGER

Risk of explosion!

Do not place tools or similar items on the

battery. Risk of short-circuit and explosion.

Risk of injury. Ensure that wounds never

come into contact with lead. Always clean

your hands after having worked with batter-

ies.

Recommended batteries

105 Ah - maintenance-free

Order No.

6.654-141.0

Volume [m

} *

2,64

Air flow [m

/h] **

1,06

* Minimum volume of the battery charg-

ing room

** Minimum air flow between the battery

charging room and the surroundings

The device requires 2 batteries

Complete set (24 V/105 Ah) incl. connect-

ing cable, order no. 4.039-287.0

Insert batteries and connect

The "Pack" model contains built-in batter-

ies.

 Pull out the battery plug.

 Tilt the waste water tank backwards.

1 Spacer

ATTENTION

Risk of damage. Mind correct polarity.

 Connect pole using the enclosed con-

necting cable.

 Connect the connection cable to the

free battery poles (+) and (-).

 Check for correct installation of the ter-

minal protective covers.

 Insert battery plug.

ATTENTION

Risk of damage due to total discharge.

Charge the batteries before commissioning

the appliance.

Charge the batteries

Note:

The appliance is equipped with a total dis-

charge protection, i.e. if the still admissible

minimum of the capacity is reached, the ap-

pliance can only be driven.

Brush drive and suction are disabled.

 Drive the appliance directly to the

charging station; avoid any steep gradi-

ents in the process.

Note:

When using other batteries (e.g. batteries

from other manufacturers), the total dis-

charge protection level for the respective

battery must be reset by the Kärcher after-

sales service.

DANGER

Risk of electric shock. Observe power sup-

ply net and fuse protection – see "Charger".

Use the charger in dry rooms with sufficient

ventilation only!

Note:

Average charging time is approx. 10 -12

hours.

The recommended chargers (suitable for

the batteries used) are regulated electroni-

cally and will automatically terminate the

charging process.

DANGER

Danger of explosion. The room, where the

machine is kept to charge the battery, must

feature a minimum volume and an air ex-

change with a minimum flow rate, depend-

ing on the type of battery (see "Recom-

mended Batteries").

Risk of explosion. The charging of wet bat-

teries is only permitted if the waste water

tank is tilted up.

 Empty the waste water tank.

 Set the key switch to position "0" and

pull out the key.

 Tilt the waste water tank backwards.

1 Battery plug, battery side

2 Battery plug, appliance side

 Detach the battery plug on the battery

side.

ATTENTION

Risk of damage!

Do not connect the charger with the

–

battery plug on the unit side.

Only use a charger that is suitable for

–

the installed battery type:

Battery type

Charger

6.654-141.0

6.654-367.0

Note: Please read the operating instruc-

tions of the charger manufacturer, espe-

cially the chapters on safety instructions!

 Connect the battery plug on the battery

side with the charger.

 Plug the mains plug of the charger into

a power outlet.

 Execute the charging process accord-

ing to the information in the operating

instructions of the charger.

Low maintenance batteries (wet

batteries)

 Add distilled water one hour before the

charging process comes to an end; fol-

low the correct acid level. There are

corresponding indicators on the battery.

At the end of the charging process, all

cells must gas.

DANGER

Risk of chemical burns. Adding water to the

battery in its discharged state can cause

the acid to leak!

Use safety glasses while handling battery

acid and follow the safety instructions to

avoid personal injury or damage to clothes.

Should the acid spray on to the skin or

clothes, rinse immediately with lots of wa-

ter.

ATTENTION

Use only distilled or desalinated water (EN

50272-T3) for filling the battery.

Do not add any substances (so-called per-

formance improving agents), else warranty

claims will not be entertained.

Maximum battery dimensions

Length

408

Width

348

Height

284