Adjustment Of The Treadmill - CAPITAL SPORTS Infinity Edge Mode D'emploi

EN
52

ADJUSTMENT OF THE TREADMILL

The running belt can expand after prolonged use and must then be readjusted.
Let the treadmill run at a speed of 3 km/h. Turn the rear adjustment screws
with the supplied Allen wrench to center the belt.
Increase belt tension
Insert the supplied Allen wrench into the rear adjusting screws. Turn it 90
degrees clockwise. This will tension the rear roller and increase the belt
tension. Repeat this for the right-hand screw. Make sure that the screws are
tightened evenly. Repeat this on both sides until the belt tension is correct.
Reduce belt tension
The belt tension is reduced in a similar way as it is increased. Turn the wrench
counterclockwise.
Center running belt
The running belt may expand after prolonged use and must be readjusted.
Run the belt at a speed of 3 km/h. Turn the rear adjustment screws with the
supplied Allen wrench to center the belt.
When the belt moves to the right,
insert the key into the right-hand
adjusting screw and turn it
90 degrees clockwise. If the belt
continues to deviate to the right, turn
the wrench 90 degrees again.
If the belt moves to the left, proceed
in the same way with the left
adjustment screw.