Output Reserved; Settings Layout; Settings Serial Ports; Settings Language - DSC GS3050-A Mode D'emploi

Figure 14 - Warning message
a) Click "Yes", to configure the Event in que-
stion at Default, and start downloading or, if
there are several Non-assigned Events, go to
the next Non-assigned Event.
b) Click "No" to stop downloading, and exit.

Output Reserved

If an Output has been programmed as Reser-
ved (refer to the 'Outputs Page'), it cannot be
activated by Events and therefore, any Events
assigned to it will be cleared. This situation in-
creases the risk of Non-assigned Events.
If an Event, in the Outputs Page, has not
been assigned to an Output, the Application
will show a warning message specifying the
Non-assigned Event (see Figure 17b).
At this point you can:
a) Click "Yes" to confirm the programmed con-
figuration, and start downloading or, if there
are several Non-assigned Events, go to the
next Non-assigned Event.
b) Click "No" to stop downloading, and exit.
Figure 13 - Status Page
18
Figure 15 - "Save it" dialogue box
Settings ➧ Layout
Select this option to view or hide the Folder
and Customer management pages.
Settings ➧ Serial Ports
This option will allow you to setup the compu-
ter serial port for the GSM-LINK. If the con-
nection is good (i.e. good communication
between the computer and the GS3050-A),
this option will be disabled.
Settings ➧ Language
This option will allow you to select the Appli-
cation language.
Settings ➧ Version
This option will allow you to select the Fir-
mware release of the GS3050-A (see Figu-
re 18). The release number can be found on
the Microprocessor [8] label.

Help

This option provides the Help guide.
GS3050-A - GSM Dialler and Interface