Telephone Numbers; Description; Area Code (Prefix); Digit To Remove - DSC GS3050-A Mode D'emploi

a)
Figure 7 - a) Folder Management, b) Customer Management, c) Status Window

Telephone Numbers

Using this table, program the Contact numbers:
1. Click the relative box in the 'Number' column.
2. Enter the prefix (Area Code) and Telepho-
ne number, if necessary* (this 20 character
field accepts digits and '+' signs).
NOTE: * If local calls DO NOT require the Area
Code, enter it in the 'Area Code' field and not
in the 'Number field' (refer to 'Prefix').

Description

Using this field, program the Contact's name.
To program a Contact name:
1. Click the relative box (1 through 8) in the
'Descriptions' column).
2. Enter the Name.

Area Code (Prefix)

Enter the Telephone number prefix (max. 4 di-
gits) in this field. The prefix will be included in
the Telephone number, when the GS3050-A
operates on the GSM Network.
Figure 8 - Telephone Page
b)

Digit to remove

If the GS3050-A is connected downstream to
an office switchboard, the Telephone numbers
(programmed on the Security system) must be
preceded by the switchboard number (usually
one digit). As the switchboard number is not
necessary when the call is sent over the GSM
Network, it must be removed from the digits
that form the Telephone number.
Enter the switchboard number in the Digit to
remove field.
D P
IALLER AGE
This page (see Figure 9) will allow you to pro-
gram all the Dialler parameters.

Set Messages

Using this table, program the Message Descriptions.
1. Click on the corresponding Description box.
2. Enter the Message description (maximum
20 characters).
c)
13