General Connections - Erreka RINO Guide Rapide D'installation Et Programmation

Turning direction
C h e c k o p e r a t i o n u s i n g t h e m i n i -
pushbuttons PUL1 (close) and PUL2
(open).
If the turning direction is not correct,
i n t e r c h a n g e t h e o p e r a t o r c a b l e s
connected in cable connectors RL1 and
RL2.
10

General connections

For the correct operation of the
encoder, ensure DIP7 is in ON.
SW2 Functions during programming (DIP1=ON)
DIP1=ON: programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON: total open/close programming
DIP1=ON and DIP3=ON: pedestrian open/close programming
DIP1=ON and DIP4=ON: total opening radio code programming
DIP1=ON and DIP6=ON: pedestrian opening radio code programming
(photocells with testing)
Encoder
(photocells without testing)
Photocell testing
Opening photocells (SG.A): place DIP6
in ON to enable testing.
Closing photocells (SG.C): place DIP9 in
ON to enable testing