Blower Function - Teuco BLOWER Manuel D'utilisation

GB
To cut the session short, press the BLOWER button a second time; the system shuts off and the display reverts to
READY.
To ensure the blower system drains completely, activate the BLOWER function after the tub has emptied so as to
dry out the pipelines.
Also,
15 minutes after unplugging the waste, the control panel will power up again; the BLOWER function starts up at
maximum speed, then switches off after 10 seconds (control panel reverts to stand-by).
10

BLOWER function

Special whirlpool essences made by Teuco can be used
when the Blower is in operation.
Do not use soaps, bath oils or other foamable products.
STARTING THE BLOWER
Pressing the "O/I" button to switch on,
the display goes into READY mode.
Press the "BLOWER" button to activate the function.
The Blower starts and the display shows:
The exact time.
The duration of the blower session (TIMER) in minutes (adjustable).
Blower in progress.
When the Blower has finished, the system shuts off and the
display reverts to READY.
DRAINING THE BLOWER SYSTEM
20 : 30
READY
Display indicating READY
status
1 5 20 : 30
BLOWER
Display indicating Blower
in progress
20 : 30
READY
Display indicating READY status
BLOWER