Scope Of Delivery - Bayrol Automatic SALT Mode D'emploi

Introduction
1
Congratulations on the purchase of your Automatic
You have chosen the best thing that can happen to your
saltwater pool.
Please be sure to read the "Safety Instructions"
supplement!
IMPORTANT: The Automatic
experienced pool dealer to ensure proper functioning!
– Please read these instructions carefully and make sure
that all necessary parts for installation as well as all
required tools are at hand.

Scope of delivery

2
1. Automatic
SALT
2. Pressure hose
3. Suction hose
4. Temperature sensor
5. Injection valve
6. Sensor holder, 2 pcs
7. Feed filter
8. Wall mounting set
9. Canister lid with hole
for suction hose
10. pH sensor
11. Redox sensor
12. Electrolysis cell
13. Smart&Easy Connector
14. Paddle­Flow­Switch
15. Cleaning solution for sensors
16. Redox buffer solution 465 mV
17. pH 7 buffer solution
Water values
3
Preparation of the pool water
To ensure proper functioning of the Automatic
essential to check the following values of the pool water and
to adjust them accordingly before starting the operation.
RECOMMENDATION
Start adjusting the water values as early as possible, as it
may take a longer time to reach the mentioned values,
depending on the pool volume.
.
SALT
must be installed by an
SALT
, it is
SALT
– Failure to comply with these instructions may result in
health and/or equipment and installation hazards!
– Only use BAYROL water care products! The use of other
products will invalidate the warranty!
– The housing of the Automatic
be opened for installation.
– Be sure to observe all general and special hazard
warnings when handling liquid water care products.
– Also observe all generally applicable safety regulations.
Wear protective clothing if necessary.
If shock chlorination of your pool water is necessary, this
should be carried out in advance.
In addition, take the Redox­Sensor out of the transport
container as early as possible and place it in a glass of pool
water.
This gives the electrode the opportunity to get used to the
pool water and helps to shorten the run­in period of the
Redox­Sensor.
EN
does not have to
SALT
29