Scope Of Delivery - Bayrol Automatic pH Mode D'emploi

Introduction
1
Congratulations on the purchase of your Automatic
value in your pool.
Please be sure to read the "Safety instructions" supplement!
IMPORTANT: The Automatic
– Please read these instructions carefully and make sure that all necessary parts for installation as well as all required tools
are at hand.
– Failure to comply with these instructions may result in health and/or equipment and installation hazards!
– Only use BAYROL water care products!
– The housing of the Automatic
– Be sure to observe all general and special hazard warnings when handling liquid water care products.
– Also observe all generally applicable safety regulations. Wear protective clothing if necessary.

Scope of delivery

2
1. Automatic
pH
2. Saddle clamp Ø 50 mm, 2 pcs
3. Pressure hose
4. Suction hose
5. Wall mounting set
6. Feed filter
7. Sensor holder
8. Injection valve
9. pH sensor
10. Canister lid with hole for suction
hose
11. Cleaning solution for sensor
12. Buffer solution pH 7
13. Teflon tape
Water values
3
Recommended values
Tolerated values
To lift
To lower
Test during season
. You have chosen the easiest way to achieve a perfectly balanced pH
pH
must be installed by an experienced pool dealer to ensure proper functioning!
pH
does not have to be opened for installation.
pH
Alkalinity/TAC (mg/l)
Min. 80
Min. 80
Add BAYROL Alca-Plus
–
monthly
pH value (pH)
7.2
7.0 – 7.4
Add pH-Plus Liquid
®
Add pH-Minus Liquid Domestic
weekly
EN
21