INTRODUCTION
Congratulations on choosing the enduro
very high standards and has undergone careful quality control procedures.
Simply by using the remote control handset you can move your caravan effortlessly into any position required
within operating guidelines.
The caravan manoeuvring system consists of two 12V motor-power rollers, a 12V electronic control unit and a
remote control handset. To function, the motor-powered rollers must be engaged against the tyres of your
caravan. The supplied cross actuation device enables you to engage both rollers at the same time from one side
of your caravan. Once this is done the manoeuvring system is ready for operation. The remote control will allow
you to move your caravan in any direction. You can even rotate the caravan on it's own axis, without moving
forwards or backwards.
Before proceeding with installation and starting to use the manoeuvring system, please read
this manual very carefully and be aware of all the safety instructions! The owner of the
caravan will always be responsible for correct use. Keep this manual inside your caravan for
future reference.
INTENDED USE
®
The enduro
EM203 caravan manoeuvring system is only suitable for single axle caravans.
Suitable only for L-profiled and U-profiled chassis with a chassis thickness between min. 2.8mm and max.
3.5mm.
Depending on the weight of the caravan, the manoeuvring system cannot overcome obstructions that are more
than about 2cm in height without assistance (please use wedges as a ramp).
The standard installation kit only provides parts for installing the manoeuvring system within the measurements
given in Fig.14.
SPECIFICATIONS
Designation
Operational voltage
Average current consumption
Maximum current consumption
Speed
Weight
Permissible overall Weight
Permissible overall Weight on 20% Gradient
Minimum width (caravan/trailer)
Maximum width (caravan/trailer)
Maximum tyre width
Power source (caravan leisure battery)
INSTALLATION SAFETY GUIDELINES
Read this user manual carefully before installation and use. Failure to comply with
these rules could result in serious injury or damage to property.
These symbols identify important safety precautions. They mean CAUTION! WARNING!
SAFETY FIRST! IMPORTANT INFORMATION!
Before starting installation under the caravan:
Check the towing load of your vehicle and the gross weight of your caravan in order to establish whether they
are designed for the additional weight. The manoeuvring system itself has a weight of about 37 kg and a
battery has a weight of about 20-25Kg.
Check the minimal installation dimensions of the caravanmover based on figure 14.
Only use adapters and accessories that are supplied or recommended by the manufacturer.
Check that the caravan is disconnected from the battery supply and the mains electrical supply.
®
caravan manoeuvring system. This has been produced according to
®
enduro
EM203
12 Volt DC
20 Ampere
100 Ampere
approx. 13cm per sec.
approx. 37Kg (exclusive battery)
1800Kg
1450Kg
1800mm
2500mm
205mm
12V 105Ah (recommended), 12V 85Ah (minimum)
®
enduro
EM203
24
Ref: EM203-UM-EAL-0211-Rev.D.