Inappropriate Use - GOK BC-1 Serie Notice De Montage Et De Service

Masquer les pouces Voir aussi pour BC-1 Serie:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
Place of operation
May not be used in potentially explosive areas.
Can cause an explosion or serious injuries.
Indicator:
• type BC-1-1, type BC-1-3, type BC-1-4, with protection type IP30, in dry and protected
rooms
• type BC-1-2, with protection type IP65, indoors and outdoors, if protected against the
weather
Probe:
• if the probe is used outdoors, it must be protected with suitable means against penetrating
humidity (e.g. with shrinking tube attached)
Product damaged due to flooding!
Causes malfunctions.
Replace the product following flooding!
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
These regulations also include the accident prevention regulations of the employers' liability
insurance associations, the VDE regulations, and the installation and operating instructions.
The specialist installer must enter and confirm that the safety device was installed in
accordance with the assembly and operating manual and the guidelines in the general
building-authority approval in the printed installation certificate.

INAPPROPRIATE USE

All uses exceeding the concept of intended use:
• e.g. operation with different operating media
• operation with inflammable operating media of categories 1, 2 or 3 with a flash point
1)
55°C
<
• outdoor use without protection type IP65
• changes to the product or parts of the product
• installation in a potentially explosive area
• installation in pressurised tanks and containers
If the device is not operated properly or it is misused, there may be a risk of injury for the
installer and the operator, risks for the device and for other property of the operator, and a risk
of a malfunction of the device itself.
Do not use this device for emergency stop mechanisms or misuse it!
Injuries and damage to health and property through misuse.
You must observe the information contained in these instructions, especially
regarding installation, start-up and maintenance.
1)
It is also necessary to comply with the divergent provisions/regulations of the EU member
states concerning areas at risk of explosion and the flash point of the operating medium!
4 / 20
Overfill prevention device type BC-1
part no. 15 700 51 g

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bc-1-4Bc-1-2

Table des Matières