Assembly - GOK BC-1 Serie Notice De Montage Et De Service

ASSEMBLY

Electric work is always to be carried out by a trained electrician.
Switzerland: The installation may only be carried out by experts with knowledge in electrical
engineering as well as regarding explosion and fire protection.
The permits, approvals, and certificates legally required for the execution of building
projects are not replaced by the general building permit and this assembly and
operating manual.
ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION!
The indicator (with IP30 type of protection) should be installed on the wall of a
regularly used, dry room. The device is to be installed at a suitable place on the wall.
For assembly in the weatherproof outdoor area, the version with IP65 type of protection must
be used.
The display unit must be connected to an overcurrent protective equipment
(OCP) which is easy to reach.
If the indicator is installed in a closed housing (e.g. control cabinet), the
connection of external signal generators and operating elements is required at a suitable
position (alarm horn or lamp, operating light, acknowledgement button, test key).
Mounting the display unit
Remove the display unit from the packaging.
Check for completeness, damage and labelling.
Unscrew 4 screws on the front of the display unit.
Remove the front of the display unit.
Drill 4 mounting holes Ø 5 mm.
Mount the display unit with the
4 enclosed S5 anchors and wood screws
3 x 35 DIN 96.
part no. 15 700 51 g
Overfill prevention device type BC-1
BC-1-2 BC-1-4
Drill 2 mounting holes Ø 5 mm.
Mount the display unit with the
2 enclosed S5 anchors and wood screws
3 x 35 DIN 96.
7 / 20