Helite EQUESTRIAN Manuel D'utilisation page 9

USER GUIDE
(1)
E. Place the ball bearing back in the recess.
The silver circle should fall back over the
ball bearing.
F. While ensuring that the ball bearing
remains in place, begin to tighten the tap
manually. Make sure the ring around the
ball bearing is inserted into the recess of
the silver piston and is flush.
G. Finish tightening the cap with the 5mm
allen wrench.
H. The end cap must be tightened until
no thread is showing and the cap will turn
no more. Do not over-tighten to avoid
damaging the trigger.
D. Place the piston back
to its position with your
finger (1) or with the allen
wrench (2) through the
cartridge hole. Be careful
not to press against the
(2)
piston's needle.
9