How To Use; Ssembling The Food Processor - Black & Decker powerpro FP2620S Mode D'emploi

BLENDER J R
† 1. Lid cap with measurement units
(Part # FP2650S-12)
† 2. Lid (Part # FP2650S-13)
† 3. 6-cup (1183 ml) glass blender jar
(Part # FP2650S-14 )
4. Handle
† 5. Gasket (Part # FP2650S-15 )
† 6. Blade assembly (Part # FP2650S-16)
† 7. Jar base (Part # FP2650S-17)
† Consumer replaceable/removable parts
1
CONTROL P NEL
1. Off/Pulse button
2. High button
3. Low button
4. Power indicator light
5
1
2
5
6
7
2
3 4
How to Use
This product is for household use only.
• Remove all packing material and any stickers from the product.
Important: Handle chopping blades and slice/shred disc carefully.
They are very sharp.
3
• Wash all removable parts as instructed in C RE ND CLE NING section of
this manual.
• Select a level, dry countertop where the appliance is to be used, allowing air
4
space on all sides to provide proper ventilation for the motor.
SSEMBLING THE FOOD PROCESSOR
How to Insert and Remove the Center Post:
The center posts of both bowls are removable:
1. Turn the bowl upside down.
B
C
D
E
2. Grasp the clear outer tabs and turn the center post
clockwise until the lower tabs are free. Lift the post out (B).
3. To return to its original position, place center post
into smaller opening in bottom of workbowl and turn
counterclockwise until tabs snap into place.
How to Lock the Workbowl in Position:
1. ttach center post to workbowl. Place the workbowl on
the base with handle turned to the right of the locking
mechanism (C) over the unlock symbol
2. Hold handle and rotate workbowl clockwise toward the
until it clicks firmly into place (D). Be sure
lock symbol
to lock the workbowl in place before attaching the blades
and cover.
How to Lock the Cover:
1. Place cover over workbowl with the small latch to the right
of the workbowl's handle (E).
2. Hold feed chute of workbowl cover and rotate cover
clockwise until cover locks into place.
Important: For your protection this appliance has an
interlock system. The processor will not operate unless the
workbowl, cover and wide-mouth feed chute are properly
locked in place.
3. Place the wide-mouth feed chute on top of the cover with
the small tab to the right of the workbowl's handle. Turn
clockwise until it clicks into position over the handle.
.
6