MIRKA LEROS 950 Mode D'emploi page 59

In order to get the maximum power from this tool it is recommended to use it with the Mirka dust extractor (or other
suitable dust extraction unit) and Mirka net sanding products. The combination of Mirka sanders, Mirka net sanding
products and Mirka dust extractor are the basis of Mirka dust-free sanding solutions.
The power cord from the tool is connected to the mains supply of the dust extractor. By connecting the tool's power cord
to the outlet on the dust extractor it is possible to use the dust extractor s autostart function.
Operating instructions
• The tool is intended to be operated as a hand held tool. The tool can be used in any position. Note! The sander can
develop a torque reaction when started.
• Make sure the sander is switched off. Select a suitable abrasive and secure it to the backing pad. Make sure the abrasive
is centred on the backing pad. For optimal performance we recommend a Mirka backing pad and Mirka Net Sanding
product.
• Switching on, changing speed and stopping the sander are described in the "Multi-purpose LED indications (see Figure
2)" chapter.
• The max rpm can be adjusted by pressing speed+ or speed–, Figure 2. The rpm can be adjusted in the range 4,000
8,000 rpm.
• When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
• It is strongly recommended that the tool is used in combination with a Mirka Dust Extractor.
Multi-purpose LED indications (see Figure 2)
Indication
Multi-purpose LED shows green
Multi-purpose LED shows green
Multi-purpose LED flashes green/red
Multi-purpose LED shows red
Multi-purpose LED quick-flashes green / red
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an app from which additional
tool functionality can be accessed. For more information on the app functionality and if it is available in your country, go
to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
Connect the power cord to mains outlet.
1.
2. Press and hold the Speed+ button while switching the tool on with the On/Off button.
3. Left LED lights up (green), to indicate that Bluetooth is active.
Bluetooth is deactivated when the tool is disconnected from mains outlet.
4.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
®
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
FCC Rules & Industry Canada's licence-exempt RSS
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B and
C, RSS-GEN, RSS-247 and FCC §15.247. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
2.
NOTE! This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
® LEROS(-S) as follows:
Meaning
Power connected
Tool switched on. Speed indication active.
Speed indication shows chosen speed.
Over temperature
Voltage out of range
en | us-ca
59
Mirka® LEROS(-S) 950