Stove Operation; Preamble; Starting The Stove; Modifying The Parameters - Palazzetti MULTIFIRE NICOLAS Notice D'installation

9 STOVE OPERATION

9.1 PREAMBLE

The stove can start combustion automatically
(pellets only) or manually (wood only).
In pellet operation, the stove can also be
programmed to start at a set time.
When off, the stove is ready to operate in wood-
Do not touch painted parts when starting the stove
or drying of certain materials used. This phenomenon will gradually disappear.
open door signal (audible alarm).
The stove will only operate properly if it has the proper electrical power supply . Do not operate the stove
without electrical power!

9.2 STARTING THE STOVE

9.2.1
Sequence of operations:
1. Open the door;
2.
the pellet feed tube;
3. ignite the wood;
4. close the door again.
The stove automatically adjusts the combustion air intake.
DANGER
burning, an automatic burn pot cleaning cycle is performed, and if the program is still active for the current time
band, the stove will start in pellet operation.
9.2.2 Automatic ignition in pellet mode
To start the stove, hold the
Automatic ignition: the stove comes with an automatic device that starts the pellet stove without using other

9.3 MODIFYING THE PARAMETERS

power supply.

9.4 CHANGING FUEL

50/144
USE AND & MAINTENANCE
button for several seconds.
mode), the stove will not switch
cod. 004771980 - 09/2014 - Palazzetti - PN - Italy
Fig. 9.1