EUROM Fireball 20T Manuel D'utilisation page 50

Air system Fireball 20T, 37T & 60T: The heavy motor drives a ventilator that sends
air into and around the combustion chamber. The air is then heated up and driven
out of the front of the heater.
Air system Fireball 20T CAP: The motor propels a fan that sucks in air. Part of this
air winds up in the combustion chamber for the fuel combustion; this air is exhausted
upwards via the flue gas tube. The other part is driven around the combustion
chamber. The air is then heated up and driven out of the front of the heater.
Safety devices:
Temperature limiter: This heater is fitted with a temperature limiter that switches the
heater off if the internal temperature rises to an unsafe level. If this safety device is
triggered, it may mean that your heater needs to be serviced.
If the temperature has dropped to under the reset-temperature, the heater can be
used again.
Electrical system safeguard: The heater's electrical system is protected by a safety
fuse. The fuse safeguards the electrical components against damage. If the heater
does not work, first check the fuse and replace it with a similar fuse if necessary.
Flame control: The heater uses a photoelectric cell to keep an eye on the
combustion chamber when the heater is operating. It will switch the heater off if the
flame goes out.
Aftercooling:
This heater is manufactured including an aftercooling system: the fan continues to
operate for some time after the heater has been switched off. The aftercooling starts
to operate when:
- The thermostat has stopped the heater.
- The overheating safeguard has stopped the heater.
- The heater has been turned off using a switch.
Aftercooling extends the lifespan of the heater. Therefore, do not remove the plug
from the socket immediately after switching off, but only after the fan has stopped.
Instructions for use
on the warning stickers and in the instruction booklet
Fueling
 Place the heater outdoors on a stable, flat and horizontal surface.
 Remove the tank cap.
 Fill the tank with clean paraffin or diesel till the fuel gauge points "F".
 Replace the cap on the tank.
Read all instructions and warnings
and check the heater for defects!
50