Electrolux ESI 8620RAX Notice D'utilisation page 10

10 www.electrolux.com
Water hardness
German de‐
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
If you use multi-tablets containing salt
and the hardness of your water is lower
than 21°dH, you can set the lowest water
softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-
tablets without salt, set the proper
water hardness level to keep the salt
refill indicator active.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Program.
• The indicators
and
• The indicator
flash.
French de‐
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
,
, and start to flash
,
go off.
continues to
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7 < 5
• The display shows the current
setting: e.g.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm the
setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of
rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 will deactivate the rinse aid
dispenser and no rinse aid will be
released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1
= level 5.
,