OHAUS Defender 5000 TD52P Mode D'emploi page 50

EN-48
The Dynamic Configurations are defined below (defaults in Bold).
Configure Item Option(Bold is default)
Dynamic Mode
Count down/Continuous
Operation Type
Manual/
Semi-Automatic/
Automatic
Start Weight
3.000 (with current unit)
Auto Tare
Off/On
Accumulate
Off/Manual/Automatic
Description
Count down:
There is a countdown time.
Continuous:
There is no countdown time.
Manual:
Place load on the pan.
Press Softkey
and countdown.
When the countdown is over, the average weight is
displayed.
Before doing next weighing, press Softkey "Reset".
Semi-Automatic:
Before weighing, the reading should be zero (Gross or
Net).
Place load (>=Start Weight) on the pan, the dynamic
weighing and countdown start automatically.
When the countdown is over, the average weight is
displayed.
Before doing next weighing, press Softkey "Reset".
Automatic:
Before weighing, the reading should be zero (Gross or
Net).
Place load (>=Start Weight) on the pan, the dynamic
weighing and countdown start automatically.
When the countdown is over, the average weight is
displayed.
After the load has been removed, the average weight
still displays until the duration time is over.
If the Softkey "Reset" is pressed, the average weight
will be cleared immediately.
Note:
During the weighing countdown, if a weight error (under
load / over load) is occurred, the weighing process will
stop immediately.
If "Auto Tare" is on, a container (weight >=5d) must
place on the pan first. After the terminal has done tare
automatically, place load on the pan to start dynamic
weighing.
If the operation type is Semi-Automatic/
Automatic, this menu will be shown. If the load bigger
than the weight, then the dynamic weighing will start.
Off: Auto tare is turn off.
On: The first stable weight (>=5d) will be tared as the
container weight.
Off: The Softkey "∑" doesn't display.
Manual: The Softkey "∑" displays. User can press the
key to accumulate the stable weight.
Automatic: The Softkey "∑" displays. The weight will
be accumulated automatically.
Defender 5000 Indicators
to start the dynamic weighing