Adjusting The Install Board - Martin Logan Statement 40XW Manuel D'installation

STEP 7: CRUCIAL STEP! ADJUSTING THE
INSTALL BOARD
7a The adjustment blocks on the install board allow for
fine tuning of the speaker opening, ensuring perfect
alignment of the finished installation. To lock in the
desired install board adjustments, tighten the 12
adjustment blocks hand-tight with a Phillips screw driver.
7b You may need to push in and hold down an adjustment
bracket so it sits flush in it's pocket while tightening the
adjustment blocks. The goal is to make sure the install
board sits as tight as possible to the positioning board
first- and then locking in that position by tightening the
adjustment block. Repeat for each of the 12 adjustment
blocks as necessary.
14
7c After tightening all the adjustment blocks, push on the
install board. If it can flex in any area, tighten the nearest
adjustment block further.