Height Adjustment; Suspension; Brake System - RIESE & MULLER Roadster 2022 Traduction De La Notice Originale

English
Height-adjustment
1. Open the quick-release skewer D.
2. Push the pin E and adjust the stem to one of the five height positions until the pin E
locks back into place.
3. Straighten the handlebar to align with the direction of travel and close the quick-
release skewer D. The lever force should increase significantly in the second half of the
closing motion. If the clamping force is not sufficient, the preload on the knurled nut
must be increased when the quick-release skewer is open.
Note
After making any changes to the position of the handlebar or stem, make sure that cables
cannot get caught. You need to be able to perform all steering movements smoothly and
safely.
Warning!
The stem must not be pulled out further than the "MIN. INSERTION" mark! Only the five
height positions with locked-in pin can be used. Before every ride, ensure that the pins are
correctly engaged and the quick-release skewers closed completely. Should the handlebar
or the stem move while riding, do not continue. Immediately take your bike to your dealer
to get the stem checked. This could otherwise lead to crashes and serious injuries.

Suspension

If the suspension audibly or noticeably sags when riding on poor road surfaces, the spring
is set too soft. You must increase the preload or the pressure. For steel springs, if the
adjustment range is not sufficient, ask your dealer to replace the spring.

Brake system

The brakes on your E-Bike enable you to achieve a high braking performance with little
effort in any situation. The braking distance, however, also depends on your riding skills,
22
Components: function and handling