Recessing The Appliance Into The Wall - Napoleon Allure Phantom Serie Manuel D'installation Et D'opération

3.5

recessing the appliance into the wall

Due to the many different finish materials used on walls, it is highly recommended to consult your local builder
before installing this appliance in the wall.
Select a location that is not prone to moisture and is located at least 36" (91.4cm) away from combustible
materials such as curtain drapes, furniture, bedding, paper, etc.
Measure the appliance and create a rough in with electrical.
A.
Remove the mesh trim front (see "mesh trim front removal" sectin).
B.
Hold the appliance up to ensure it will fit into the framing.
C.
If the appliance is fully recessed into the wall:
D.
• Bend the 2 top tabs upward on the mesh trim front (Fig. 3, next page).
• Use 6 screws (supplied) to lock the appliance into the wall with the existing 2 side flanges (Fig. 1).
• Install the media and reinstall the mesh trim front.
If partial recess into the wall:
E.
• Use the 2 mounting brackets (supplied) to lock the appliance to the wall (Fig. 2).
note:
2 sets of holes are provided for recessing into wall. The wall structure may limit how far the
appliance can be recessed. Use the appropriate set of holes when recessing to the frame, it may be
necessary to use the 4 holes on the top and bottom.
Fig. 1
note:
It is recommended the walls of the appliance enclosure be finished (ie. drywall) to avoid exposed insulation or
vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is maintained.
installation
EN
Fig. 2
13
W415-2172 / D / 10.30.20