Erbauer ERN647ATL-I Mode D'emploi page 4

11. Do not use the tool for any other than its intended use.
12. Do not carry out any alternations and/or modifications to the tool.
13. Always disconnect the tool from air supply before replacing any accessories,
performing any repair and maintenance, moving to another work area, or passing
the tool to another person.
14. Never use the tool if it is defective, damaged, or operating abnormally.
15. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that affects the tool operation. If damaged, have the tool serviced
before using.
16. Keep working parts of the tool away from hands and body.
17. Do not carry the tool by the air hose.
18. Do not apply excessive force of any kind to the tool. Let the tool perform the work
at the rate as it was designed.
19. Do not remove any labels on the tool. Replace if they become obscured or
damaged.
20. Always maintain the tool with care. Keep it clean for the best and safest
performance.
21. It is not recommended that quick change couplings should be located directly at
the air inlet, as they add weight and could fail due to vibration.
22. This tool vibrates with use. Continuous operation of this tool might be harmful to
your hands or arms. Stop using the tool if discomfort, a tingling feeling or pain
occurs. Resume work after recovery. Seek medical advice if a serious symptom
occurs.
Air nibbler safety instructions
1. Always use the air nibbler in the manner and for the functions described in this
manual.
2. Always ensure the tool is disconnected from the air supply when replacing die
and blade.
3. Only use qualified blades. Never use blunt blades which require excessive
pressure and can break from fatigue. Do not use damaged blades.
4. Always keep your fingers away from the point of cutting. Wear suitable gloves to
protect hands.
5. Be aware of the sharp edges produced by the cutting operation.
6. If necessary, use clamps, vices or proper devices to securely fix the workpiece.
Use supports for long material. Hold the material securely to prevent tilting during
the cuts.
7. Hold the tool firmly. Use both hands to control the air shear if necessary.
8. Never carry the tool by the air supply hose.
9. Always disconnect the tool from the air supply when the tool is not required for
immediate use in order to avoid accidental start.
AIR NIBBLER