Publicité
Les langues disponibles
Les langues disponibles
NOTE:
For Cooling model
AUTO
SPEED
9
8
For Heating model
AUTO
SPEED
9
8
Normal Operating Sounds
• You may hear a pinging noise caused by
water hitting the condenser, on rainy days,
or when the humidity is high. This design
features helps remove moisture and improve
efficiency.
• You may hear the thermostat click when the
compressor cycles on and off.
• Water will collect in the base pan during rain
or days of high humidity. The water may
overflow and drip of the outside part off the
unit.
• The fan may run even when the compressor
is not on
1.
Digital Display:
Without timer setting, the
operation mode is Cooling, Dry, Fan, Heat and
Auto, and the set temperature will be displayed.
Time will be displayed under timer setting.
2.
and
Button:
control panel and remote to increase or decrease
the Set Temperature or Timer.
Temperature range: 61 ~88
3.
Power Button:
Turn the air conditioner on and
off.
4. Mode Button:
Press the mode button to cycle
through the various modes: Cool, Dry, Fan and
Auto, or Heat.
1
AUTO
MODE
7
6
5
4
1
AUTO
MODE
HEAT
7
6
5
4
Use these buttons on the
or 16 ~31 .
Cool Mode: The cooling function allows the air
conditioner to cool the room and at the same time
reduces Air humidify. Press the MODE button to
activate the cooling function. To optimize the
function of the air conditioner, adjust the
temperature and the speed by pressing the button
indicated.
Dry Mode: This function reduces the humidity of
2
the air to make the room more comfortable. Press
MODE button to set the DRY mode. An automatic
function of alternating cooling cycles and air fan
3
is activated.
Fan Mode: The conditioner works in only
ventilation. Press MODE button to set the FAN
mode. With pressing FAN SPEED button the
speed changes in the following sequence: Hi, Med
and Lo in FAN mode. The remote control also
stores the speed that was set in the previous
2
mode of operation.
Auto Mode: In AUTO mode the unit automatically
chooses the fan speed and the mode of operation
3
(COOL, DRY, Heat or FAN).In this mode the fan
speed and the temperature are set automatically
according to the room temperature (tested by the
temperature sensor which is incorporated in the
indoor unit.).
Heat Mode: The heating function allows the air
conditioner to heat the room. Press the MODE
button to activate the cooling function. To optimize
the function of the air conditioner, adjust the
temperature and the speed by pressing the button
indicated.
5. Timer Button:
panel and remote to set the Timer.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the rest time by
pressing the button
desired rest time is displayed.
Timer On: When the unit is off, press TIMER
button at the first time, set the temperature with
pressing the button
button at the second time, set the rest time with
pressing the button
button at the third time, confirm the setting, then
the rest time to next automatical switching-on
could be read on the display of the machine.
N
: It can be set to automatically turn off or on
in 0.5-24 hours. Each press of the
buttons will increase or decrease the timer. The
Timer can be set in 0.5 hour increments below 10
hours, and 1 hour increments above 10 hours.
The SET light will turn on while setting.
To cancel the set function, press the TIMER
button again.
13
Use these buttons on the control
or
until the
or
. Press TIMER
or
. Press TIMER
Publicité
Chapitres
