Stihl FS 45 Notice D'emploi page 15

8
2
7
5
6
Slip the mowing head (2) over the
N
shaft (5) and engage hex recess (7)
on the external hexagon (6).
Fit the cap (8) on the mowing head
N
– screw it clockwise on to the shaft
as far as stop and tighten it down
firmly.
FS 45, FS 46
STIHL AutoCut C 5-2
8
2
9
Slip the mowing head (2) on to the
N
shaft – as AutoCut 5-2.
Turn the spool (9) clockwise until
N
the two arrow heads line up –
secure the spool in this position.
Insert the cap (8) in the spool, press
N
it down as far as stop and turn it
clockwise at the same time.
Turn the cap until you feel
N
resistance and then tighten it down
firmly by hand.
STIHL PolyCut 6-3
10
11
5
Fit the thrust plate on the shaft.
N
Insert the nut (10) in the mowing
N
head.
Screw the mowing head (11)
N
clockwise on to the shaft (5) as far
as stop.
Block the shaft – see "Blocking the
N
Shaft".
Tighten down the mowing head.
N
Remove the locking pin.
English
13