Connecting Control Cable; Installation Of Cables C14 And Mach14; Shift Cable Connection - Ultraflex B 501 Manuel D'installation Et D'entretien

ULTRAFLEX
WARNING
Make sure the chosen angular position allows the correct stroke of the cable.

3.4 Connecting control cable

1 Select a direct path with a minimum number of bends and without any obstacles.
WARNING
Avoid too narrow bends (the minimum bend radius is 203 mm (8")).
NOTICE
Outboard engine installations require an additional length of about 120 cm (47") of the cables to allow
engine swing.
The cables can be fixed with suitable cable hangers (supplied separately) or routed through segments of
conduit (supplied separately too) for long straight runs.
WARNING
To avoid the control stiffening, do not fix the cables near the control outlet (the minimum fixing
distance is 500 mm) and in any case do not use fixing systems that can deform the cable conduit.
2 CONTROL B501:
Remove the rear
cover (4) of the control
by (unscrewing) the
screws (5) so as to
reach easily the
elements where the
cables are to be fixed.
3 A specific fitting kit is available for each cable type, K59 kit is also included with both single levers
B501 and B502.
To install the cables on the control/controls follow the instructions provided with each kit.
To install the cables C14 and MACH14 follow the instructions given below.

3.5 Installation of cables C14 and Mach14

3.5.1 Shift cable connection

1 Position the
control box on a plane
surface as in the
picture (the Ultraflex
logo on the lever must
be visible).
Remove the cable
fastener (7) from the
plate (8) through the
screws (9).
5
9
8
7
SINGLE LEVER CONTROL B501 AND B502
Installation and maintenance manual
CONTROL B502:
5
Split the two boxes
(6), by removing
the screws (5).
5
4
2 Mount the cable
making sure the
cable cylinder (10) is
placed inside the
plate hole (11).
6
5
10
11
page 9
- of 63