Hornbach 10329557 Manuel D'installation Et De L'utilisateur page 209

Attaching the L-brackets to the
Use two M6x12 full thread bolts
and two Ø6 washers
the L-brackets to the front bar of
the retractable screen. Ensure
the L-brackets are securely con-
nected and all bolts are tight.
Once this connection is complet-
ed, the retractable screen can
move along the rails inside the
left and right beams.
Adjustment, in case the front bar
does not parallel the backside
Loosen the two screws of the
sleeve on the motor shaft on
one side. Push back the sleeve
towards the motor and align the
front rod with the backside beam.
Push the sleeve back onto the
shaft of the dented wheel and
secure it with the screws.
12
front bar
to join
13
beam:
4
13
ENGLISH | 209