Installation; Installation Site; Wind Resistance Classes - Hornbach 10329557 Manuel D'installation Et De L'utilisateur

Installation

Installation site

WARNING
Consult a specialist, if there is any doubt on the
load carrying capacity of the installation site.
Prior to the installation, check if the wall the instal-
lation site has sufficient load carrying capacity. Spe-
cial care needs to be taken if the installation shall
be carried out at an insulated wall, as the increasing
demands on thermal insulation reduce the tensile
forces of anchor bolts and other fastenings. Make sure
the installation site is straight and allows the correct
positioning of the pergola awning in terms of height of
the beams. Additionally, ensure the ground is sound
enough to support the load of the pergola awning
with added load of water or snow stored on top of
the retractable screen for safety measures. The non-
retractable parts of the awning are designed in a way,
that loads of max. 800 Pa (800 N/m
deformation (if the screen is fully retracted).

Wind resistance classes

This retractable screen is designed to withstand Beau-
fort force 5 wind speeds, which equals wind resist-
ance class 2. The combination of wall type and mount-
ing material used at your installation site might result
in a lower wind resistance class for your retractable
screen.
WIND RESIST-
BEAUFORT
ANCE CLASS FORCE
0 1-3
1 4
2 5
3
6
200 | ENGLISH
) do not lead to
2
An installation specialist will be able to provide infor-
mation about the wind resistance class the pergola
awning can withstand after the installation. The table
below can be used to identify different wind speeds by
observing tree movement:
WIND SPEED IMPLICATION
up to 19 km/h Leaves and small twigs constantly moving
20 - 27 km/h Small branches begin to move,
loose paper is raised from the ground
28 - 37 km/h Branches of moderate size move, small trees in leaf
begin to swat
38 - 48 km/h Large branches in motion, umbrella use becomes dif-
ficult
WARNING
To prevent risks during installation, the installer
must have sufficient knowledge in the following
qualifications:
•
Occupational safety and health (OSH), opera-
tional safety and accident prevention regula-
tions given by the Employer's Liability Insurance
Association
•
Handling and transport of long and heavy com-
ponents
•
Handling of ladders and scaffolding
•
Evaluation of basic structures of a building
•
Handling of tools and machines
•
Handling and installation of fastening equipment
•
Commissioning and operation of products
•
Electrical work and repairs must be performed
by a qualified electrician
In case not every qualification can be covered by
the installer, seek for a professional installation
specialist to perform the installation.