Hornbach 10329557 Manuel D'installation Et De L'utilisateur page 205

Mounting the framing backside
After both wall brackets have
been mounted properly you can
fix the awning.
At least two ladders or treads
are required for steps 5 to 11.
Ensure that the ladders/treads
are firmly resting on the ground
so that you cannot fall. Only use
ladders/treads that are suitable
for such assembly work.
Place the framing with the back-
side beam on the wall mounts
and immediately secure it with
the following parts:
M10 locking nut
Ø10 washers
M10 nuts and the M10x90 full
thread bolts throughout the
entire assembly (2 x).
Ensure the connections are tight
and secure before moving on to
the frontside beam.
6
,
,
ENGLISH | 205