Steam Ironing - Beper 50.810 Manuel D'instructions

Steam iron Use instructions
Kind of fabric
AcetateAcrylicNylon
PolyesterViscose
Silk
WoolLight cot-
tonLight linen
Cotton Thin linen
Starched fabrics
Linen
The table is valid for fabrics and not for brilliant surfaces, with relief printings or folds which must be
ironed with low temperature. Before using the iron, always make sure that the temperature of iron is
adapted to the type of fabric: wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a low tempe-
rature (like synthetic fabrics) and always progress with the highest temperatures.
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest
temperature, and then finding the temperature more adapted. If clothing becomes "brilliant", stop
immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol

STEAM IRONING

Before plugging the appliance, make sure the tank is full of water.
Check the steam indicator is on position « steam »
Temperature Ironing instructions
position
Ironing without steam. Follow the instructions indicated
on clothing. This type of fabric requires a very soft ironing.
Ironing without steam.Ironing on the back of clothing. Se-
lect the lowest temperature for ironing mix fabric.
Ironing without steam.Ironing on the back of clothing.
Ironing with steam.Ironing on the back of clothing. Put a
wet cloth on the fabric in order to avoid the "brilliant "ef-
fect.
Ironing with steam.Moist the fabrics before ironing. The
thicker and starched fabrics must be a little wetter than
the light fabrics which can be ironed directly: the dark co-
lours and clothing with embroidery must be ironed on the
back.
Ironing with vapour.Use a lot of steam and iron the dark
clothing on the back in order to avoid the "brilliant "effect.
: that means that the fabric must not be ironed.
to use steam function.
17