Beper 50.810 Manuel D'instructions page 19

Steam iron Use instructions
After ironing, unplug the appliance from the socket and empty the tank.
To empty the tank turn over the iron above the sink (or other).
Otherwise place the iron in vertical position and plug it to the socket.
Select the temperature indicator on "MAX" and steam indicator on steam symbol METTERE FIGU-
RA , and let the steam come out from the iron by pressing steam switch.
CLEANING
Unplug the appliance from the socket.
To remove dirt on the soleplate, use a wet cloth or with a little quantity of non abrasive detergent
when the soleplate is still hot.
For hard dirt, use special detergent.
Always dry the soleplate after cleaning.
Clean the whole iron with a wet cloth without detergent.
Do not use metallic sponge or abrasive detergent.
AUTO-CLEANING
Set the MAX. temperature with the temperature selector control.
By pressing auto-cleaning button, release the steam several times steam in order to eliminate the
internal residues
Keep the auto-cleaning button pressed for few seconds until the light indicator illuminates. Repeat
3 or 4 times.
STORAGE
Always empty the tank after every use.
Unplug the appliance from the socket and let it cool.
ADVICE FOR SAVING ENERGY
The most important part of energy is consumed when used steam. In order to reduce it, read as
follows :
• always start ironing with fabric which need the lower temperature.
• set steam function and temperature as described in the instruction manual.
Iron only when it is necessary. If possible use spray function instead of steam function.
• iron clothes when they are still wet and reduce the steam function. If you use a dryer machine,
select « ironing » program that allow you to easily iron clothes.
• if clothes are enough wet, set the steam indicator on "zero".
• when having a break, store the iron in vertical position.
19