Steam Ironing - Beper 50.131 Manuel D'instructions

EN
Steam iron Use instructions
The number of points on the thermostat (8) indicate the temperature from the lower one (•) to the
higher one (•••).The table is valid for fabrics and not for brilliant surfaces, with relief printings or folds
which must be ironed with low temperature.
Before using the iron, always make sure that the temperature of iron is adapted to the type of fabric:
wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a low tempe-
rature (like synthetic fabrics) and always progress with the highest temperatures..
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest
temperature, and then finding the temperature more adapted. If clothing becomes "brilliant", stop
immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol : that means that the fabric must not be ironed.

STEAM IRONING

Before plugging the appliance, make sure the filler cap (2) is full of water.
Check the steam indicator (3) is on position « steam » to use steam function.
When used for the first time, press several times the burst button (4), in order to eliminate dirt, resi-
due from the manufacture.
Steam ironing is possible when setting the thermostat (8) on symbol (•) ; when the temperature
increased the steam also increase until symbol max. (•••).
The light indicator (7) illuminate and when the soleplate is at good temperature switch off.
Pressing the burst button (4), steam function is activated.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If burst button (4) is pressed before reaching the setting temperature, steam function won't
work but only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of burst button (4), by more than 5 seconds.
To obtain a non-stop steam, keep steam indicator (3) in position
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.
15