Parts And Accessories; Ironing With Steam - Beper 50.934 Manuel D'instructions

Steam station Use instructions

PARTS AND ACCESSORIES

1- Boiler
2 - Iron boiler connection cable (supply cable + steam hose)
3 - Supply cable with plug
4 - Boiler on/off switch with pilot lamp
5 - Iron on/off switch with pilot lamp
6 - "Steam ready" pilot lamp
7 - Safety boiler cap
8 - Iron stand
9 - Thermostat knob
10 - Steam button
11 - Thermostat pilot lamp
12 - Continuous steam button
13 - Water measure
14 - "Lack water" pilot lamp
15 - Steam adjustment
NOTICE

IRONING WITH STEAM

NOTE: Only iron resistant to heater.
Make sure that the safety boiler cap is well closed, otherwise part of the steam will escape
from this opening. The steam ready" pilot lamp switch on and off itself during the use ; this
is the correct way and shows that the appliance always contains the pressure.
When there is a lack of water into the tank, the "lack water" pilot lamp illuminates, turn off the
iron and open the safety boiler cap only when completely cool.
Press switch on/off (4) and for the water gets very hot (about 8 minutes).
Then press on/off steam button to turn on the iron and select desired temperature with the thermo-
stat knob (9).
When the thermostat pilot lamp (11) turn off, that means the temperature is reached and the iron
ready to use. It takes about 8 minutes to the steam station to reach the desired temperature.
When the steam station is ready the steam ready pilot lamp (6) illuminates.
When used for the first time, clean the iron with a cloth.
Press steam button (10) to get steam.
Release the steam button when steam is no longer necessary.
This appliance is able to generate steam in vertical position and can be used to iron easily fabrics
with steam jet.
13