Steam Ironing; Water Spray; Dry Ironing - Beper 50.947 Manuel D'instructions

Steam Iron Use instructions
The table is valid for fabrics and not for brilliant surfaces, with relief printings or folds which must be
ironed with low temperature. Before using the iron, always make sure that the temperature of iron is
adapted to the type of fabric: wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a low tempe-
rature (like synthetic fabrics) and always progress with the highest temperatures.
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest
temperature, and then finding the temperature more adapted. If clothing becomes "brilliant", stop
immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol that means that the fabric must not be ironed.

STEAM IRONING

Before plugging the appliance, make sure the tank is full of water.
Check the steam indicator is on position « steam » to use steam function.
When used for the first time, press several times steam switch, in order to eliminate dirt, residue
from the manufacture.
Steam ironing is possible when setting the thermostat on symbol (•) ; when the temperature increa-
sed the steam also increase until symbol max. (•••).
The light indicator illuminate and when the soleplate is at good temperature switch off.
Pressing the steam switch, steam function is activated.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If steam switch is pressed before reaching the setting temperature, steam function won't work but
only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of steam switch, by more than 5 seconds.
To obtain a non-stop steam, keep steam indicator in position
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.

WATER SPRAY

Check that the tank is full of water, direct the spray forward the clothes. Press several times the
water switch.
When used for the first time, it is recommended to press several times on water switch before you
obtain the desired spray.
Attention: do not use water spray function on silk.

DRY IRONING

Set the steam indicator on in order to not to use steam function . Set the soleplate temperature
by using the thermostat .
The light indicator illuminates and switch off when the soleplate is at good temperature.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
15