Filling The Water Tank; Steam Ironing - Beper 50.101 Manuel D'instructions

Steam iron Use instructions
Some warnings
Always unplug the product when it is not in use, when filling or emptying the tank.
Make sure that the power cord does not come into contact with hot parts of the iron.
Do not leave the iron unattended while it is on.
Before first use
At the first use the iron could emit some smoke, this is normal and does not compromise the functioning of the
product.
Before using the product for the first time, remove the protective film from the plate and clean it with a soft cloth.
Use
Always check the label with the ironing instructions on the article to be ironed and follow them.
Turn the thermostat knob to set the desired temperature, following the legend below.
SYMBOL FABRIC
Do not iron
Synthetic, Nylon, Acryilic, Rayon
Wool, Silk
Cotton, Flax
Insert the plug into the socket. The operating light will turn on.
When the light switches off, it will be possible to start ironing.
It is recommended to wait until the light switches off before starting ironing.
We recommend to set first a low temperature and then switch to an higher one.

FILLING THE WATER TANK

Unplug the power cord from the power outlet before filling the water tank.
Keep the iron in a horizontal position.
Slowly pour the water through the appropriate hole, using the supplied measuring cup.
Be careful not to overfill the tank (see the mark), to prevent the water from escaping.
NOTE: The iron is designed for use with tap water, however, if the water is very hard, it is advisable to use a
mixture of distilled water and tap water.
It is advisable to empty the water tank after each use, in order to avoid the formation of limescale, mold and bad
odors. It is recommended to allow the iron to cool for a few minutes before emptying the tank.
SPRAY
As long as there is enough water in the water tank, you can use the "Spray" button regardless of the set tempe-
rature, and that ironing steam or dry.
When using the iron for the first time, it is advisable to press the "Spray" button a few times before obtaining an
adequate spray, as the water must be able to fill the circulation pipes before exiting.

STEAM IRONING

Set the thermostat knob to the position "● ●" or "● ● ●".
Set the steam adjustment button to the desired position.
CAUTION: Take care not to come into contact with the expelled steam. Do not direct the steam jet to-
wards people and / or animals.
WARNING: If the water in the tank runs out during use, wait until the iron has cooled down before filling
it again.
10