Switching The Time Display - Marantz professional CDR633 Mode D'emploi

Note
• "OPC" stands for Optimum Power Control. This is a
function that optimizes the power of the laser used to
record the disc.
• If a digital signal is recorded as the recording source
but no signal (or an inappropriate signal) is being
input, an error message of "D-IN UNLOCK!" is dis-
played.
5
Adjust the input level.
For details on the input level, refer to "Adjusting
the input signal" (→ p.25).
Set the level as high as possible without allowing
the [OVER] indication of the meters shown in the
upper part of the display to light.
Clipping will produce digital noise if [OVER]
lights. Be aware that unlike the case of analog
recording, there is no headroom beyond the [0]
point of the meter.
Note
• When recording a CD, we recommend that as a gen-
eral rule you set the menu mode VOLUME at "0.0
dB". This allows you record the recording-source CD
without clipping.
6
To start recording, press the
ton.
Input a signal from the playback unit etc. you've
connected as the recording source.
If you want to stop or pause recording, proceed as
follows.
To pause recording
Press the (pause) button. Press the
button once again to resume recording.
To stop recording
Press the (stop) button.
The display will indicate "PMA Writing" and
the recorded content will be written to the disc.
Caution
• While the display indicates "PMA Writing" the
recorded content is being written to the disc. button
operations are disabled during this time.
• Never subject the CDR633 to severe vibration or turn
off the power while the "PMA Writing" indication is
shown. The recorded content will not be written cor-
rectly if you do so.
5 – Recording—Switching the time display

Switching the time display

Here's how to switch the time display during record-
ing (or in record-ready mode).
During recording (or in record-ready mode), press the
DISPLAY button on the front panel (or the remote
control unit).
Each time you press the button, you will cycle
through the following four types of time display. The
currently selected display type is shown by the fol-
lowing indicators.
No indication
The elapsed recording time of the current track is dis-
played.
[REMAIN] lit
The remaining recordable time of the disc is dis-
(play) but-
played.
[TOTAL] lit
The total elapsed recording time of the entire disc is
displayed.
[TOTAL] and [REMAIN] lit
The remaining recordable time of the disc is dis-
played.
(play)
Note
For details on the time displays while playing or paused,
refer to "Switching the time display" in the "Playback" sec-
tion ( → p.14).
27
DISPLAY button