Fade-In/Out; Sync Recording - Marantz professional CDR633 Mode D'emploi

5 – Recording—Fade-in/out

Fade-in/out

When recording, you can fade-in the input signal
from silence to the specified level, or fade-out from
the current level to silence. The fade-in/out times can
be specified independently.
1
As described in "Basic operation in Menu
mode" (→ p.13), access the "FADE IN?"
menu item and press the ENTER button.
The display will indicate "Fade In> XXs" (you
can select 1–30).
Here you can specify the fade-in time.
2
Turn the MULTI JOG dial to specify the fade-
in time.
3
Press the MENU button to return from menu
mode to normal mode.
By selecting the "FADE OUT?" menu item in
step 1, you can specify the fade-out time in the
same way.
4
To execute a fade-in, press the FADER but-
ton on the front panel (or the remote control
unit) from record-ready mode.
Recording will begin at the same time as the fade-
in, and the display will indicate "Fade In".
5
To execute a fade-out, press the FADER but-
ton on the front panel (or the remote control
unit) during recording.
The fade-out will begin, and recording will stop
when the fade reaches silence. The display will
indicate "Fade Out" while the fade-out is occur-
ring.
Note
You are able to operate fade-out during a fade-in, or fade-
in during a fade-out.

Sync recording

Sync recording makes recording begin automatically
when the input signal exceeds a specified level (the
sync level) and end automatically when silence is
detected at the end.
FADER button
1
After entering record-ready mode (→
p.26), press the SYNC REC button repeat-
edly to select "Sync ALL" or "Sync 1".
Each time you press the button, the display will
cycle through the following settings: "Sync ALL"
(repeatedly sync-record the input source) →
"Sync 1" (sync-record only once) → "Sync
OFF" (sync-record is off).
If "Sync ALL" is selected, the [SYNC] indicator
in the display will light, and the CDR633 will be
ready to sync-record.
If "Sync 1" is selected, the [SYNC] indicator in
the display will blink, and the CDR633 will be
ready to sync-record.
2
If necessary, you can adjust the sync level
as follows.
1
2
3
28
As described in "Basic operation in Menu
mode" (→ p.13), access the "SYNC
LEVEL?" menu item and press the MULTI
JOG dial.
The display will indicate "S_LEV> XXXdB".
Turn the MULTI JOG dial to set the sync
level. The range is –24 dB to –72 dB (6 dB
steps).
Press the MENU button or ENTER button
to exit menu mode.
2
1, 4