Maintenance And Care - Husky 10-26K Instructions D'installation

To Tow:
1. Align trailer and tow vehicle in a straight line on a level surface.
2. Pull up on link and push in on the handle then release link.
View from cab side of truck bed
Views showing pull handle and system in driving position.
3. When the handle is put into the driving position, make note whether the pivot stops
rotated or not. If they did then proceed to step 5.
4. If the pivot stops did not rotate then you will need to set the trailer brakes and then pull
the tow vehicle forward slightly until you hear the pivot stops actuate. Then proceed to
step 5.
5. Set the trailer brakes and slowly move the tow vehicle rearward until the "HUSKY 10-
26K" stops moving and you hear the pivot stops engage.
View showing pivot stops in the driving "locked" position from inside of the driver side
1. Every 5,000 miles check all bolted connections
to ensure the proper torque is applied. (see
page 1 for proper torque values based on
fastener size and grade.) Also, apply fresh
grease to the pivot shafts to ensure trouble free
movement of the pivot stops.
2. Using compressed air, clean cloth or hand
brush periodically wipe off the sliding surface of
the "HUSKY 10-26K" and also check to ensure
there are no foreign objects in the hole
recesses of the lower sliding pad as needed.
3. Do not use any kind of lubrication on the lower
sliding pad as this may affect sliding performance and accelerate wear.
4. Before each trip, it is a good idea to check the actuating mechanisms of the "26K Husky
10" for proper movement and make any corrections/adjustments if needed.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual
March 15, 2012-REV 5
Front of Tow Vehicle
assembly.

Maintenance and Care

See www.huskytow.com for Warranty Information / Tech Support
Page 15 of 16
Front of Tow Vehicle