Husky 10-26K Instructions D'installation page 7

1. Place driver side assembly & passenger side assembly into base rail slots.
2. Insert base rail pins from rearward side of base rails and secure with clips.
3. Lift clevis/yoke located on driver side pivot up as far as it will go.
4. Place Husky pivot plate on recesses on pivot stops by tipping the passenger side
assembly outward to get the plate in place. Slotted tabs on plate should rest in recesses
on pivot stops.
Using 1/4" bolts, flat washers and lock washers, thread into holes on pivot stops finger
tight only.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual
March 15, 2012-REV 5
"HUSKY 10-26K" INSTALLATION
See www.huskytow.com
Page 7 of 16
for Warranty Information / Tech Support