Husky 10-26K Instructions D'installation page 14

OPERATING INSTRUCTIONS
To Maneuver:
The "HUSKY 10-26K" has an "anti-bind" feature that will allow you to change the
locking handle position if the pivot stops are in a bind.
1. Align trailer and tow vehicle in a straight line on a level surface.
2. Pull up on link and out on handle then release link.
View from cab side of truck bed
Views showing pull handle and system in maneuver position.
3. When the handle is put into the maneuver position, make note whether the pivot stops
rotated or not. If they did then proceed to step 5.
4. If the pivot stops did not rotate then you will need to set the trailer brakes and then
back the tow vehicle up slightly until you hear the pivot stops actuate. Then proceed to
step 5.
5. Set the trailer brakes and slowly pull the tow vehicle forward until the "HUSKY 10-26K"
stops moving and you hear the pivot stops engage.
View showing pivot stops in the maneuver "locked" position from inside of the driver side
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual
March 15, 2012-REV 5
Front of Tow Vehicle
assembly.
See www.huskytow.com for Warranty Information / Tech Support
Page 14 of 16
Front of Tow Vehicle